Ipv6 Pim Dr-Priority; Ipv6 Pim Join-Prune-Interval - NETGEAR ProSafe M7100-24X User Manual

Parameters Description
hash-mask-length
Length of a mask (32 bits maximum) that is to be ANDed with the group address before
the hash function is called. All groups with the same seed hash correspond to the same
RP. For example, if this value was 24, only the first 24 bits of the group addresses
matter. This allows you to get one RP for multiple groups.
priority
Priority of the candidate BSR. The range is an integer from 0 to 255. The BSR with the
larger priority is preferred. If the priority values are the same, the router with the larger
IP address is the BSR. The default value is 0.
interval
(Optional) Indicates the BSR candidate advertisement interval. The range is from 1 to
16383 seconds. The default value is 60 seconds.
no ipv6 pim bsr-candidate
Use this command to disable the router to announce its candidacy as a bootstrap router
(BSR).
Format
no ipv6 pim bsr-candidate interface [<unit/slot/port> | vlan
<1-4093>] [hash-mask-length] [priority]
Mode
Global Config

ipv6 pim dr-priority

Use this command to set the priority value for which a router is elected as the designated
router (DR).
Default
1
Format
ipv6 pim dr-priority <0-2147483647>
Mode
Interface Config
no ipv6 pim dr-priority
Use this command to disable the interface from being the BSR border.
Format
no ipv6 pim dr-priority
Mode
Interface Config

ipv6 pim join-prune-interval

Use this command to configure the interface join/prune interval for the PIM-SM router. The
join/prune interval is specified in seconds. This parameter can be configured to a value from
0 to 18000.
Default
60
ProSafe Managed Switch
IPv6 Multicast Commands
424