Show Trapflags - NETGEAR ProSafe M7100-24X User Manual

(Netgear Switch)#show snmptrap
Community Name IpAddress
Mytrap 0.0.0.0

show trapflags

Use this command to display trap conditions. The command's display shows all the enabled
OSPFv2 and OSPFv3 trapflags. Configure which traps the switch should generate by
enabling or disabling the trap condition. If a trap condition is enabled and the condition is
detected, the SNMP agent on the switch sends the trap to all enabled trap receivers. You do
not have to reset the switch to implement the changes. Cold and warm start traps are always
generated and cannot be disabled.
Format
show trapflags
Mode
Privileged EXEC
Term Definition
Authentication
Can be enabled or disabled. The factory default is enabled. Indicates whether
Flag
authentication failure traps will be sent.
Link Up/Down
Can be enabled or disabled. The factory default is enabled. Indicates whether link status
Flag
traps will be sent.
Multiple Users
Can be enabled or disabled. The factory default is enabled. Indicates whether a trap will
Flag
be sent when the same user ID is logged into the switch more than once at the same
time (either through Telnet or the serial port).
Spanning Tree
Can be enabled or disabled. The factory default is enabled. Indicates whether spanning
Flag
tree traps are sent.
ACL Traps
May be enabled or disabled. The factory default is disabled. Indicates whether ACL traps
are sent.
DVMRP Traps
Can be enabled or disabled. The factory default is disabled. Indicates whether DVMRP
traps are sent.
OSPFv2 Traps
Can be enabled or disabled. The factory default is disabled. Indicates whether OSPF
traps are sent. If any of the OSPF trap flags are not enabled, then the command displays
disabled. Otherwise, the command shows all the enabled OSPF traps' information.
OSPFv3 Traps
Can be enabled or disabled. The factory default is disabled. Indicates whether OSPF
traps are sent. If any of the OSPFv3 trap flags are not enabled, then the command
displays disabled. Otherwise, the command shows all the enabled OSPFv3 traps'
information.
PIM Traps
Can be enabled or disabled. The factory default is disabled. Indicates whether PIM traps
are sent.
ProSafe Managed Switch
IPv6 Address Snmp Version
2001::1 SNMPv2
Management Commands
671
Mode
Enable show trapflags