Secure Shell (Ssh) Commands; Show Telnetcon - NETGEAR ProSafe M7100-24X User Manual

Term Definition
Outbound
The number of minutes an outbound Telnet session is allowed to remain inactive before
Telnet Login
being logged off.
Timeout
Maximum
The number of simultaneous outbound Telnet connections allowed.
Number of
Outbound
Telnet Sessions
Allow New
Indicates whether outbound Telnet sessions will be allowed.
Outbound
Telnet Sessions

show telnetcon

Use this command to display the current inbound Telnet settings. In other words, these
settings apply to Telnet connections initiated from a remote system to the switch.
Format
show telnetcon
Modes
• Privileged EXEC
• User EXEC
Term Definition
Remote
This object indicates the number of minutes a remote connection session is allowed to
Connection
remain inactive before being logged off. May be specified as a number from 1 to 160.
Login Timeout
The factory default is 5.
(minutes)
Maximum
This object indicates the number of simultaneous remote connection sessions allowed.
Number of
The factory default is 5.
Remote
Connection
Sessions
Allow New
New Telnet sessions will not be allowed when this field is set to no. The factory default
Telnet Sessions
value is yes.

Secure Shell (SSH) Commands

This section describes the commands you use to configure SSH access to the switch. Use
SSH to access the switch from a remote management host.
Note: The system allows a maximum of 5 SSH sessions.
ProSafe Managed Switch
Management Commands
626