Ipv6 Mld Router; Ipv6 Mld Query-Interval; Ipv6 Mld Query-Max-Response-Time - NETGEAR ProSafe M7100-24X User Manual

ipv6 mld router

Use this command, in the administrative mode of the router, to enable MLD in the router.
Default
Disabled
Format
ipv6 mld router
Mode
• Global Config
• Interface Config
no ipv6 mld router
Use this command, in the administrative mode of the router, to disable MLD in the router.
Default
Disabled
Format
no ipv6 mld router
Mode
• Global Config
• Interface Config

ipv6 mld query-interval

Use this command to set the MLD router's query interval for the interface. The query-interval
is the amount of time between the general queries sent when the router is the querier on that
interface. The range for <query-interval> is 1 to 3600 seconds.
Default
125
Format
ipv6 mld query-interval <query-interval>
Mode
Interface Config
no ipv6 mld query-interval
Use this command to reset the MLD query interval to the default value for that interface.
Format
no ipv6 mld query-interval
Mode
Interface Config

ipv6 mld query-max-response-time

Use this command to set the MLD querier's maximum response time for the interface and this
value is used in assigning the maximum response time in the query messages that are sent
on that interface. The range for <query-max-response-time> is 0 to 65535 milliseconds.
Default
10000 milliseconds
Format
ipv6 mld query-max-response-time <query-max-response-time>
Mode
Interface Config
ProSafe Managed Switch
IPv6 Multicast Commands
428