Router Ospf; Enable (Ospf); Open Shortest Path First Commands; General Ospf Commands - NETGEAR M6100 Series Reference Manual

Open Shortest Path First Commands

This section describes the commands you use to view and configure Open Shortest Path
First (OSPF), which is a link-state routing protocol that you use to route traffic within a
network. This section contains the following subsections:
•

General OSPF Commands

• OSPF Interface Commands
• IP Event Dampening Commands
• OSPFv2 Stub Router Commands
• OSPF Show Commands
General OSPF Commands

router ospf

Use this command to enter Router OSPF mode.
Format
router ospf
Mode Global Config

enable (OSPF)

This command resets the default administrative mode of OSPF in the router (active).
Default enabled
Format
enable
Mode Router OSPF Config
no enable (OSPF)
This command sets the administrative mode of OSPF in the router to inactive.
Format
no enable
Mode Router OSPF Config
M6100 Series Switches
on page 702
on page 722
on page 729
on page 734
on page 735
Routing Commands
702