Autovoip; Periodic {Start|End} Time; Show Time-Range - NETGEAR ProSafe M7100-24X User Manual

periodic {start|end} time

Use this command to configure the start/end time for the time-range.
Format
periodic {start|end} time
Mode
Time-Range Config

show time-range

Use this command to display a time range and all the absolute/periodic time entries that are
defined for the time range. Use the
display. When
name
Format
show time-range
Mode
Privileged EXEC
Term Definition
Number of Time
Number of time ranges configured in the system.
Ranges
Time Range Name
Name of the time range.
Time Range Status
Status of the time range (active/inactive).
Absolute start
Start time and day for absolute time entry.
Absolute end
End time and day for absolute time entry.
Periodic Entries
Number of periodic entries in a time-range.
Periodic start
Start time and day for periodic entry.
Periodic end
End time and day for periodic entry.

AutoVOIP

AutoVoIP detects the VoIP streams and put the VoIP streams in the specific VLAN (auto-voip
VLAN) and provides higher class of service to the VoIP streams automatically (both data and
signaling). It detects the VoIP streams in two modes.
Protocol-based Auto VoIP
In a VoIP system, various signaling protocols are used to establish the connection between
two VoIP devices. The supported signaling protocols are SIP, H.323, and SCCP.
OUI-based Auto VoIP
The OUI-based Auto VoIP feature prioritizes VoIP packets based on the OUI bytes in the
source MAC address. A default list of OUIs is maintained. User is also allowed to configure
OUIs that need prioritization apart from the default OUI list. Up to 128 OUIs are allowed on
the device or system, including the default OUIs.
ProSafe Managed Switch
parameter to identify a specific time range to
name
is not specified, all the time ranges defined in the system are displayed.
Quality of Service (QoS) Commands
486