Debug Rip Packet - NETGEAR ProSafe M7100-24X User Manual

Format
debug ping packet
Mode
Privileged EXEC
A sample output of the trace message is shown below.
<15> JAN 01 00:21:22 192.168.17.29-1 SIM[181040176]: sim_debug.c(128) 20 % Pkt TX - Intf:
1/0/1(1),
SRC_IP:10.50.50.2, DEST_IP:10.50.50.1, Type:ECHO_REQUEST
<15> JAN 01 00:21:22 192.168.17.29-1 SIM[182813968]: sim_debug.c(82) 21 % Pkt RX - Intf:
1/0/1(1), S
RC_IP:10.50.50.1, DEST_IP:10.50.50.2, Type:ECHO_REPLY
The following parameters are displayed in the trace message:
Parameter Definition
TX/RX
TX refers to a packet transmitted by the device. RX refers to packets received by the
device.
Intf
The interface that the packet came in or went out on. Format used is unit/slot/port
(internal interface number). Unit is always shown as 1 for interfaces on a non-stacking
device.
SRC_IP
The source IP address in the IP header in the packet.
DEST_IP
The destination IP address in the IP header in the packet.
Type
Type determines whether or not the ICMP message is a REQUEST or a RESPONSE.
no debug ping packet
This command disables tracing of ICMP echo requests and responses.
Format
no debug ping packet
Mode
Privileged EXEC

debug rip packet

This command turns on tracing of RIP requests and responses. This command takes no
options. The output is directed to the log file.
Default
disabled
Format
debug rip packet
Mode
Privileged EXEC
A sample output of the trace message is shown below.
<15> JAN 01 00:35:15 192.168.17.29-1 RIP[181783160]: rip_map_debug.c(96) 775 %
Pkt RX on Intf: 1/0/1(1), Src_IP:43.1.1.1 Dest_IP:43.1.1.2
ProSafe Managed Switch
Utility Commands
590