Spanning Tree Protocol (Stp) Commands; Spanning-Tree Auto-Edge; Spanning-Tree Bpdufilter - NETGEAR ProSafe M7100-24X User Manual

Spanning Tree Protocol (STP) Commands

This section describes the commands you use to configure Spanning Tree Protocol (STP).
STP helps prevent network loops, duplicate messages, and network instability.
spanning-tree
This command sets the spanning-tree operational mode to enabled.
Default
enabled
Format
spanning-tree
Mode
Global Config
no spanning-tree
This command sets the spanning-tree operational mode to disabled. While disabled, the
spanning-tree configuration is retained and can be changed, but is not activated.
Format
no spanning-tree
Mode
Global Config

spanning-tree auto-edge

This command enables auto-edge on the interface or range of interfaces. When enabled, the
interface becomes an edge port if it does not see BPDUs for edge delay time.
Default
enabled
Format
spanning-tree auto-edge
Mode
Interface Config
no spanning-tree auto-edge
This command disables auto-edge on the interface or range of interfaces.
Format
no spanning-tree auto-edge
Mode
Interface Config

spanning-tree bpdufilter

Use this command to enable BPDU Filter on an interface or range of interfaces.
Default
disabled
Format
spanning-tree bpdufilter
Mode
Interface Config
ProSafe Managed Switch
Switching Commands
29