Show Port-Security; Show Port-Security Dynamic; Show Port-Security Static - NETGEAR ProSafe M7100-24X User Manual

show port-security

This command displays the port-security settings. If you do not use a parameter, the
command displays the settings for the entire system. Use the optional parameters to display
the settings on a specific interface or on all interfaces.
Format
show port-security [{<unit/slot/port> | all}]
Mode
Privileged EXEC
Term Definition
Admin Mode
Port Locking mode for the entire system. This field displays if you do not supply any
parameters.
For each interface, or for the interface you specify, the following information appears:
Term Definition
Admin Mode
Port Locking mode for the Interface.
Dynamic Limit
Maximum dynamically allocated MAC Addresses.
Static Limit
Maximum statically allocated MAC Addresses.
Violation Trap
Whether violation traps are enabled.
Mode

show port-security dynamic

This command displays the dynamically locked MAC addresses for the port.
Format
show port-security dynamic [lag <lag-intf-num> | <unit/slot/port>]
Mode
Privileged EXEC
Term Definition
MAC Address
MAC Address of dynamically locked MAC.

show port-security static

This command displays the statically locked MAC addresses for port.
Format
show port-security static [lag <lag-intf-num> | <unit/slot/port>]
Mode
Privileged EXEC
Term Definition
MAC Address
MAC Address of statically locked MAC.
ProSafe Managed Switch
Switching Commands
171