Show Ip Rip; Show Ip Rip Interface Brief - NETGEAR ProSafe M7100-24X User Manual

show ip rip

This command displays information relevant to the RIP router.
Format
show ip rip
Modes
• Privileged EXEC
• User EXEC
Term Definition
RIP Admin
Enable or disable.
Mode
Split Horizon
None, simple or poison reverse.
Mode
Auto Summary
Enable or disable. If enabled, groups of adjacent routes are summarized into single
Mode
entries, in order to reduce the total number of entries The default is enable.
Host Routes
Enable or disable. If enabled the router accepts host routes. The default is enable.
Accept Mode
Global Route
The number of route changes made to the IP Route Database by RIP. This does not
Changes
include the refresh of a route's age.
Global queries
The number of responses sent to RIP queries from other systems.
Default Metric
The default metric of redistributed routes if one has already been set, or blank if not
configured earlier. The valid values are 1 to 15.
Default Route
The default route.
Advertise

show ip rip interface brief

This command displays general information for each RIP interface. For this command to
display successful results routing must be enabled per interface (i.e., ip rip).
Format
show ip rip interface brief
Modes
• Privileged EXEC
• User EXEC
Term Definition
Interface
Valid slot and port number separated by forward slashes.
IP Address
The IP source address used by the specified RIP interface.
Send Version
The RIP version(s) used when sending updates on the specified interface. The types are
none, RIP-1, RIP-1c, RIP-2
Receive Version The RIP version(s) allowed when receiving updates from the specified interface. The
types are none, RIP-1, RIP-2, Both
ProSafe Managed Switch
Routing Commands
313