dot1x supplicant max-start
Use this command to configure the number of attempts that the supplicant makes to find the
authenticator before the supplicant assumes that there is no authenticator.
Default
3
Format
dot1x supplicant max-start <1-10>
Mode
Interface Config
no dot1x supplicant max-start
Use this command to set the max-start value to the default.
Format
no dot1x supplicant max-start
Mode
Interface Config
dot1x supplicant timeout start-period
Use this command to configure the start period timer interval to wait for the EAP identity
request from the authenticator.
Default
30 seconds
Format
dot1x supplicant timeout start-period <1-65535 seconds>
Mode
Interface Config
no dot1x supplicant timeout start-period
Use this command to set the start-period value to the default.
Format
no dot1x supplicant timeout start-period
Mode
Interface Config
dot1x supplicant timeout held-period
Use this command to configure the held period timer interval to wait for the next
authentication on previous authentication fail.
Default
30 seconds
Format
dot1x supplicant timeout held-period <1-65535 seconds>
Mode
Interface Config
ProSafe Managed Switch
Switching Commands
91