Spanning-Tree Mst Vlan - NETGEAR ProSafe M7100-24X User Manual

are masked according to the 802.1s specification. This causes the priority to be rounded
down to the next lower valid priority.
Default
32768
Format
spanning-tree mst priority <mstid> <0-61440>
Mode
Global Config
no spanning-tree mst priority
This command sets the bridge priority for a specific multiple spanning tree instance to the
default value. The parameter <mstid> is a number that corresponds to the desired existing
multiple spanning tree instance.
If 0 (defined as the default CIST ID) is passed as the <mstid>, this command sets the
Bridge Priority parameter for the common and internal spanning tree to the default value.
Format
no spanning-tree mst priority <mstid>
Mode
Global Config

spanning-tree mst vlan

This command adds an association between a multiple spanning tree instance and one or
more VLANs so that the VLAN(s) are no longer associated with the common and internal
spanning tree. The parameter <mstid> is a number that corresponds to the desired existing
multiple spanning tree instance. The vlan range can be specified as a list or as a range of
values. To specify a list of VLANs, enter a list of VLAN IDs, each separated by a comma with
no spaces in between. To specify a range of VLANs, separate the beginning and ending
VLAN ID with a dash ("-").
Format
spanning-tree mst vlan <mstid> <vlanid>
Mode
Global Config
no spanning-tree mst vlan
This command removes an association between a multiple spanning tree instance and one
or more VLANs so that the VLAN(s) are again associated with the common and internal
spanning tree.
Format
no spanning-tree mst vlan <mstid> <vlanid>
Mode
Global Config
ProSafe Managed Switch
Switching Commands
37