•
For multicast MAC address filters with destination ports configured, the maximum number
of static filters supported is 256.
For example, for current platforms you can configure the following combinations:
•
Unicast MAC and source port (max = 20)
•
Multicast MAC and source port (max=20)
•
Multicast MAC and destination port (only) (max=256)
•
Multicast MAC and source ports and destination ports (max=20)
Format
macfilter <macaddr> <vlanid>
Mode
Global Config
no macfilter
This command removes all filtering restrictions and the static MAC filter entry for the MAC
address <macaddr> on the VLAN <vlanid>. The <macaddr> parameter must be specified
as a 6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6.
The <vlanid> parameter must identify a valid VLAN.
Format
no macfilter <macaddr> <vlanid>
Mode
Global Config
macfilter adddest
Use this command to add the interface to the destination filter set for the MAC filter with the
given <macaddr> and VLAN of <vlanid>. The <macaddr> parameter must be specified as
a 6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6. The <vlanid> parameter
must identify a valid VLAN.
Note:
Configuring a destination port list is only valid for multicast MAC
addresses.
Format
macfilter adddest <macaddr> <vlanid>
Mode
Interface Config
no macfilter adddest
This command removes a port from the destination filter set for the MAC filter with the given
<macaddr> and VLAN of <vlanid>. The <macaddr> parameter must be specified as a
ProSafe Managed Switch
Switching Commands
122