Lldp (802.1Ab) Commands; Show Port-Security Violation; Lldp Transmit; Lldp Receive - NETGEAR ProSafe M7100-24X User Manual

show port-security violation

This command displays the source MAC address of the last packet discarded on a locked
port.
Format
show port-security violation [lag <lag-intf-num> | <unit/slot/port>]
Mode
Privileged EXEC
Term Definition
MAC Address
MAC Address of discarded packet on locked port.

LLDP (802.1AB) Commands

This section describes the command you use to configure Link Layer Discovery Protocol
(LLDP), which is defined in the IEEE 802.1AB specification. LLDP allows stations on an 802
LAN to advertise major capabilities and physical descriptions. The advertisements allow a
network management system (NMS) to access and display this information.

lldp transmit

Use this command to enable the LLDP advertise capability.
Default
enabled
Format
lldp transmit
Mode
Interface Config
no lldp transmit
Use this command to return the local data transmission capability to the default.
Format
no lldp transmit
Mode
Interface Config

lldp receive

Use this command to enable the LLDP receive capability.
Default
enabled
Format
lldp receive
Mode
Interface Config
ProSafe Managed Switch
Switching Commands
172