Storm-Control Broadcast Level (Global); Storm-Control Broadcast Rate (Global) - NETGEAR ProSafe M7100-24X User Manual

Format
storm-control broadcast
Mode
Global Config
no storm-control broadcast
This command disables broadcast storm recovery mode for all interfaces.
Format
no storm-control broadcast
Mode
Global Config

storm-control broadcast level (Global)

This command configures the broadcast storm recovery threshold for all interfaces as a
percentage of link speed and enables broadcast storm recovery. If the mode is enabled,
broadcast storm recovery is active, and if the rate of L2 broadcast traffic ingressing on an
interface increases beyond the configured threshold, the traffic will be dropped. Therefore,
the rate of broadcast traffic will be limited to the configured threshold. This command also
enables broadcast storm recovery mode for all interfaces.
Default
5
Format
storm-control broadcast level <0-100>
Mode
Global Config
no storm-control broadcast level
This command sets the broadcast storm recovery threshold to the default value for all
interfaces and disables broadcast storm recovery.
Format
no storm-control broadcast level
Mode
Global Config

storm-control broadcast rate (Global)

Use this command to configure the broadcast storm recovery threshold for all interfaces in
packets per second. If the mode is enabled, broadcast storm recovery is active, and if the
rate of L2 broadcast traffic ingressing on an interface increases beyond the configured
threshold, the traffic is dropped. Therefore, the rate of broadcast traffic is limited to the
configured threshold.
Default
0
Format
storm-control broadcast rate <0-14880000>
Mode
Global Config
ProSafe Managed Switch
Switching Commands
95