Port Lacpmode; Port Lacpmode Enable All; Port Lacptimeout (Interface Config) - NETGEAR ProSafe M7100-24X User Manual

no port-channel static
This command sets the static mode on a particular port-channel (LAG) interface to the default
value. This command will be executed only for interfaces of type port-channel (LAG).
Format
no port-channel static
Mode
Interface Config

port lacpmode

This command enables Link Aggregation Control Protocol (LACP) on a port.
Default
enabled
Format
port lacpmode
Mode
Interface Config
no port lacpmode
This command disables Link Aggregation Control Protocol (LACP) on a port.
Format
no port lacpmode
Mode
Interface Config

port lacpmode enable all

This command enables Link Aggregation Control Protocol (LACP) on all ports.
Format
port lacpmode enable all
Mode
Global Config
no port lacpmode enable all
This command disables Link Aggregation Control Protocol (LACP) on all ports.
Format
no port lacpmode enable all
Mode
Global Config

port lacptimeout (Interface Config)

This command sets the timeout on a physical interface of a particular device type (actor or
partner) to either long or short timeout.
Default
long
Format
port lacptimeout {actor | partner} {long | short}
Mode
Interface Config
ProSafe Managed Switch
Switching Commands
113