Ip Rip Send Version - NETGEAR ProSafe M7100-24X User Manual

no ip rip receive version
This command configures the interface to allow RIP control packets of the default version(s)
to be received.
Format
no ip rip receive version
Mode
Interface Config

ip rip send version

This command configures the interface to allow RIP control packets of the specified version
to be sent. The value for <mode> is one of: rip1 to broadcast RIP version 1 formatted
packets, rip1c (RIP version 1 compatibility mode) which sends RIP version 2 formatted
packets via broadcast, rip2 for sending RIP version 2 using multicast, or none to not allow
any RIP control packets to be sent.
Default
ripi2
Format
ip rip send version {rip1 | rip1c | rip2 | none}
Mode
Interface Config
no ip rip send version
This command configures the interface to allow RIP control packets of the default version to
be sent.
Format
no ip rip send version
Mode
Interface Config
hostroutesaccept
This command enables the RIP hostroutesaccept mode.
Default
enabled
Format
hostroutesaccept
Mode
Router RIP Config
no hostroutesaccept
This command disables the RIP hostroutesaccept mode.
Format
no hostroutesaccept
Mode
Router RIP Config
ProSafe Managed Switch
Routing Commands
311