Ip Pim Rp-Candidate - NETGEAR ProSafe M7100-24X User Manual

<groupaddress> is the group address supported by the RP. The parameter <groupmask>
is the group mask for the group address. The optional keyword override indicates that if
there is a conflict, the RP configured with this command prevails over the RP learned by
BSR.
Default
disabled
Format
ip pim rp-address <rp-address> <group-address> <group-mask>
[override]
Mode
Global Config
no ip pim rp-address
This command is used to statically remove the RP address for one or more multicast groups.
Format
no ip pim rp-address <rp-address> <group-address> <group-mask>
[override]
Mode
Global Config

ip pim rp-candidate

This command is used to configure the router to advertise itself as a PIM candidate
rendezvous point (RP) to the bootstrap router (BSR).
Format
ip pim rp-candidate interface <interface-num> <group-address>
<group-mask> {interval <interval>}
Mode
Global Config
Parameter Description
interface-num
The IP address associated with this interface type and number is advertised as a
candidate RP address. This interface must be enabled with PIM.
group-address,
The multicast group address and prefix that are advertised in association with the RP
group-mask
address.
interval
(Optional) Indicates the RP candidate advertisement interval. The range is from 1 to
16383 seconds. The default is 60 seconds.
no ip pim rp-candidate
This command is used to disable the router to advertise itself as a PIM candidate rendezvous
point (RP) to the bootstrap router (BSR).
Format
no ip pim rp-candidate interface <interface-num>
Mode
Global Config
ProSafe Managed Switch
IP Multicast Commands
333