Show Ipv6 Access-Lists - NETGEAR ProSafe M7100-24X User Manual

no ipv6 traffic-filter
This command removes an IPv6 ACL identified by <name> from the interface(s) in a given
direction.
Format
no ipv6 traffic-filter <name> {{control-plane|in|out}|vlan <vlan-id>
{in|out}}
Modes
• Global Config
• Interface Config

show ipv6 access-lists

This command displays an IPv6 access list and all of the rules that are defined for the IPv6
ACL. Use the [name] parameter to identify a specific IPv6 ACL to display.
Format
show ipv6 access-lists [name]
Mode
Privileged EXEC
Term Definition
Rule Number
The ordered rule number identifier defined within the IPv6 ACL.
Action
The action associated with each rule. The possible values are Permit or Deny.
Match All
Indicates whether this access list applies to every packet. Possible values are True or
False.
Protocol
The protocol to filter for this rule.
Source IP
The source IP address for this rule.
Address
Source L4 Port
The source port for this rule.
Keyword
Destination IP
The destination IP address for this rule.
Address
Destination L4
The destination port for this rule.
Port Keyword
IP DSCP
The value specified for IP DSCP.
Flow Label
The value specified for IPv6 Flow Label.
Log
Displays when you enable logging for the rule.
Assign Queue
The queue identifier to which packets matching this rule are assigned.
Mirror Interface
The unit/slot/port to which packets matching this rule are copied.
Redirect
The unit/slot/port to which packets matching this rule are forwarded.
Interface
Time Range
Displays the name of the time-range if the IPv6 ACL rule has referenced a time range.
Name
Rule Status
Status(Active/Inactive) of the IPv6 ACL rule.
ProSafe Managed Switch
Quality of Service (QoS) Commands
483