Dot1X Re-Authenticate; Dot1X Re-Authentication; Dot1X System-Auth-Control - NETGEAR ProSafe M7100-24X User Manual

no dot1x port-control all
This command sets the authentication mode on all ports to the default value.
Format
no dot1x port-control all
Mode
Global Config

dot1x re-authenticate

This command begins the re-authentication sequence on the specified port. This command is
only valid if the control mode for the specified port is "auto" or "mac-based". If the control
mode is not "auto" or "mac-based", an error will be returned.
Format
dot1x re-authenticate <unit/slot/port>
Mode
Privileged EXEC

dot1x re-authentication

This command enables re-authentication of the supplicant for the specified port.
Default
disabled
Format
dot1x re-authentication
Mode
Interface Config
no dot1x re-authentication
This command disables re-authentication of the supplicant for the specified port.
Format
no dot1x re-authentication
Mode
Interface Config

dot1x system-auth-control

Use this command to enable the dot1x authentication support on the switch. While disabled,
the dot1x configuration is retained and can be changed, but is not activated.
Default
disabled
Format
dot1x system-auth-control
Mode
Global Config
ProSafe Managed Switch
Switching Commands
80