Tacacs-Server Timeout - NETGEAR ProSafe M7100-24X User Manual

no tacacs-server source interface
Use this command in Global Configuration mode to remove the global source interface
(Source IP selection) for all TACACS+ communications between the TACACS+ client and the
server.
Format
no tacacs-server source-interface
Mode
Privileged Exec

tacacs-server timeout

Use the tacacs-server timeout command to set the timeout value for communication
with the TACACS+ servers. The <timeout> parameter has a range of 1-30 and is the
timeout value in seconds.
Default
5
Format
tacacs-server timeout <timeout>
Mode
Global Config
no tacacs-server timeout
Use the no tacacs-server timeout command to restore the default timeout value for all
TACACS servers.
Format
no tacacs-server timeout
Mode
Global Config
key
Use the key command in TACACS Configuration mode to specify the authentication and
encryption key for all TACACS communications between the device and the TACACS server.
This key must match the key used on the TACACS daemon. The <key-string> parameter
specifies the key name. For an empty string use " ". (Range: 0 - 128 characters).
Text-based configuration supports TACACS server's secrets in encrypted and non-encrypted
format. When you save the configuration, these secret keys are stored in encrypted format
only. If you want to enter the key in encrypted format, enter the key along with the encrypted
keyword. In the show running config command's display, these secret keys are displayed in
encrypted format. You cannot show these keys in plain text format.
Format
key [<key-string> | encrypted <key-string>]
Mode
TACACS Config
ProSafe Managed Switch
Management Commands
687