Show Mail-Server Config - NETGEAR ProSafe M7100-24X User Manual

security
Use this command to set the email alerting security protocol by enabling the switch to use
TLS authentication with the SMTP Server. If the TLS mode is enabled on the switch but the
SMTP sever does not support TLS mode, no email is sent to the SMTP server.
Default
none
Format
security {tlsv1 | none}
Mode
Mail Server Config
port
Use this command to configure the TCP port to use for communication with the SMTP server.
The recommended port for TLSv1 is 465, and for no security (i.e. none) it is 25. However, any
nonstandard port in the range 1 to 65535 is also allowed.
Default
25
Format
port {465 | 25 | 1–65535}
Mode
Mail Server Config
username
Use this command to configure the login ID that the switch uses to authenticate with the
SMTP server.
Default
admin
Format
username name
Mode
Mail Server Config
password
Use this command to configure the password that the switch uses to authenticate with the
SMTP server.
Format
password password
Mode
Mail Server Config

show mail-server config

Use this command to display information about the email alert configuration.
Format
show mail-server {ip-address | hostname | all } config
Mode
Privileged EXEC
ProSafe Managed Switch
Utility Commands
539