Show Ipv6 Ospf Range; Show Ipv6 Ospf Stub Table - NETGEAR ProSafe M7100-24X User Manual

Term Definition
Events
Number of times this neighbor relationship has changed state, or an error has occurred.
Retransmission
An integer representing the current length of the retransmission queue of the specified
Queue Length
neighbor router Id of the specified interface.

show ipv6 ospf range

This command displays information about the area ranges for the specified <areaid>. The
<areaid> identifies the OSPF area whose ranges are being displayed.
Format
show ipv6 ospf range <areaid>
Modes
• Privileged EXEC
• User EXEC
Term Definition
Area ID
The area id of the requested OSPF area.
IP Address
An IP address which represents this area range.
Lsdb Type
The type of link advertisement associated with this area range.
Advertisement
The status of the advertisement: enabled or disabled.

show ipv6 ospf stub table

This command displays the OSPF stub table. The information below will only be displayed if
OSPF is initialized on the switch.
Format
show ipv6 ospf stub table
Modes
• Privileged EXEC
• User EXEC
Term Definition
Area ID
A 32-bit identifier for the created stub area.
Type of Service Type of service associated with the stub metric. For this release, Normal TOS is the only
supported type.
Metric Val
The metric value is applied based on the TOS. It defaults to the least metric of the type of
service among the interfaces to other areas. The OSPF cost for a route is a function of
the metric value.
Import
Controls the import of summary LSAs into stub areas.
Summary LSA
ProSafe Managed Switch
IPv6 Commands
405