Storm-Control Unicast (Global); Storm-Control Unicast Level (Global) - NETGEAR ProSafe M7100-24X User Manual

no storm-control unicast rate
This command sets the unicast storm recovery threshold to the default value for an interface
and disables unicast storm recovery.
Format
no storm-control unicast rate
Mode
Interface Config

storm-control unicast (Global)

This command enables unicast storm recovery mode for all interfaces. If the mode is
enabled, unicast storm recovery is active, and if the rate of unknown L2 unicast (destination
lookup failure) traffic ingressing on an interface increases beyond the configured threshold,
the traffic will be dropped. Therefore, the rate of unknown unicast traffic will be limited to the
configured threshold.
Default
disabled
Format
storm-control unicast
Mode
Global Config
no storm-control unicast
This command disables unicast storm recovery mode for all interfaces.
Format
no storm-control unicast
Mode
Global Config

storm-control unicast level (Global)

This command configures the unicast storm recovery threshold for all interfaces as a
percentage of link speed, and enables unicast storm recovery. If the mode is enabled, unicast
storm recovery is active, and if the rate of unknown L2 unicast (destination lookup failure)
traffic ingressing on an interface increases beyond the configured threshold, the traffic will be
dropped. Therefore, the rate of unknown unicast traffic will be limited to the configured
threshold.
Default
5
Format
storm-control unicast level <0-100>
Mode
Global Config
ProSafe Managed Switch
Switching Commands
100