Vlan Participation All; Vlan Port Acceptframe All - NETGEAR ProSafe M7100-24X User Manual

vlan participation all

This command configures the degree of participation for all interfaces in a VLAN. The ID is a
valid VLAN identification number.
Format
vlan participation all {exclude | include | auto} <1-4093>
Mode
Global Config
You can use the following participation options:
Participation Definition
Options
include
The interface is always a member of this VLAN. This is equivalent to registration fixed.
exclude
The interface is never a member of this VLAN. This is equivalent to registration
forbidden.
auto
The interface is dynamically registered in this VLAN by GVRP. The interface will not
participate in this VLAN unless a join request is received on this interface. This is
equivalent to registration normal.

vlan port acceptframe all

This command sets the frame acceptance mode for all interfaces.
Default
all
Format
vlan port acceptframe all {vlanonly | all}
Mode
Global Config
The modes defined as follows:
Mode Definition
VLAN Only
Untagged frames or priority frames received on this interface are discarded.
mode
Admit All mode
Untagged frames or priority frames received on this interface are accepted and assigned
the value of the interface VLAN ID for this port.
With either option, VLAN tagged frames are forwarded in accordance with the IEEE 802.1Q
VLAN Specification.
no vlan port acceptframe all
This command sets the frame acceptance mode for all interfaces to Admit All. For Admit All
mode, untagged frames or priority frames received on this interface are accepted and
ProSafe Managed Switch
Switching Commands
50