Dos-Control Tcpsynfin; Dos-Control Tcpfinurgpsh; Dos-Control Icmpv - NETGEAR ProSafe M7100-24X User Manual

dos-control tcpsynfin

This command enables TCP SYN and FIN Denial of Service protection. If the mode is
enabled, Denial of Service prevention is active for this type of attack. If packets ingress
having TCP flags SYN and FIN set, the packets will be dropped if the mode is enabled.
Default
disabled
Format
dos-control tcpsynfin
Mode
Global Config
no dos-control tcpsynfin
This command sets disables TCP SYN & FIN Denial of Service protection.
Format
no dos-control tcpsynfin
Mode
Global Config

dos-control tcpfinurgpsh

This command enables TCP FIN and URG and PSH and SEQ=0 checking Denial of Service
protections. If the mode is enabled, Denial of Service prevention is active for this type of
attack. If packets ingress having TCP FIN, URG, and PSH all set and TCP Sequence Number
set to 0, the packets will be dropped if the mode is enabled.
Default
disabled
Format
dos-control tcpfinurgpsh
Mode
Global Config
no dos-control tcpfinurgpsh
This command sets disables TCP FIN and URG and PSH and SEQ=0 checking Denial of
Service protections.
Format
no dos-control tcpfinurgpsh
Mode
Global Config

dos-control icmpv4

This command enables Maximum ICMPv4 Packet Size Denial of Service protections. If the
mode is enabled, Denial of Service prevention is active for this type of attack. If ICMPv4 Echo
Request (PING) packets ingress having a size greater than the configured value, the packets
will be dropped if the mode is enabled.
Default
disabled <512>
ProSafe Managed Switch
Switching Commands
197