Show Ip Ospf - NETGEAR ProSafe M7100-24X User Manual

show ip ospf

This command displays information relevant to the OSPF router.
Format
show ip ospf
Mode
Privileged EXEC
Note: Some of the information below displays only if you enable OSPF
and configure certain features.
Term Definition
Router ID
A 32-bit integer in dotted decimal format identifying the router, about which information is
displayed. This is a configured value.
OSPF Admin
Shows whether the administrative mode of OSPF in the router is enabled or disabled.
Mode
This is a configured value.
ASBR Mode
Indicates whether the ASBR mode is enabled or disabled. Enable implies that the router
is an autonomous system border router. Router automatically becomes an ASBR when it
is configured to redistribute routes learnt from other protocol. The possible values for the
ASBR status is enabled (if the router is configured to re-distribute routes learned by other
protocols) or disabled (if the router is not configured for the same).
RFC 1583
Indicates whether 1583 compatibility is enabled or disabled. This is a configured value.
Compatibility
External LSDB
The maximum number of non-default AS-external-LSA (link state advertisement) entries
Limit
that can be stored in the link-state database.
Exit Overflow
The number of seconds that, after entering overflow state, a router will attempt to leave
Interval
overflow state.
Spf Delay Time
The number of seconds between two subsequent changes of LSAs, during which time
the routing table calculation is delayed.
Spf Hold Time
The number of seconds between two consecutive spf calculations.
Flood Pacing
The average time, in milliseconds, between LS Update packet transmissions on an
Interval
interface. This is the value configured with the
LSA Refresh
The size, in seconds, of the LSA refresh group window. This is the value configured with
Group Pacing
the timers pacing lsa-group
Time
Opaque
Shows whether the router is capable of sending Opaque LSAs. This is a configured
Capability
value.
Autocost Ref
Shows the value of auto-cost reference bandwidth configured on the router.
BW
ABR Status
Shows whether the router is an OSPF Area Border Router.
ProSafe Managed Switch
timers pacing flood
command.
Routing Commands
284
command.