Logging Console; Logging Host - NETGEAR ProSafe M7100-24X User Manual

no logging cli-command
This command disables the CLI command Logging feature.
Format
no logging cli-command
Mode
Global Config

logging console

This command enables logging to the console. You can specify the <severitylevel>
value as either an integer from 0 to 7 or symbolically through one of the following keywords:
emergency (0), alert (1), critical (2), error (3), warning (4), notice (5), info (6),
or debug (7).
Default
disabled; critical when enabled
Format
logging console [severitylevel]
Mode
Global Config
no logging console
This command disables logging to the console.
Format
no logging console
Mode
Global Config

logging host

This command enables logging to a host. You can configure up to eight hosts. The
<ipaddr|hostname> is the IP address of the logging host. The <addresstype> indicates
the type of address ipv4 or ipv6 or dns being passed. The <port> value is a port number
from 1 to 65535. You can specify the <severitylevel> value as either an integer from 0 to
7 or symbolically through one of the following keywords: emergency (0), alert (1),
critical (2), error (3), warning (4), notice (5), info (6), or debug (7).
The end user can configure either an IPv4 or IPv6 address or a host name for a Syslog
collector among the list of servers.
Default
• port—514
• level—critical (2)
Format
logging host <ipaddr|hostname> <addresstype>
[<port>][<severitylevel>]
Mode
Global Config
ProSafe Managed Switch
Utility Commands
530