Classofservice Dot1P-Mapping; Classofservice Ip-Dscp-Mapping - NETGEAR ProSafe M7100-24X User Manual

Note: Commands you issue in the Interface Config mode only affect a
single interface. Commands you issue in the Global Config mode
affect all interfaces.

classofservice dot1p-mapping

This command maps an 802.1p priority to an internal traffic class. The <userpriority>
values can range from 0-7. The <trafficclass> values range from 0-6, although the
actual number of available traffic classes depends on the platform. For more information
about 802.1p priority, see
Format
classofservice dot1p-mapping <userpriority> <trafficclass>
Modes
• Global Config
• Interface Config
no classofservice dot1p-mapping
This command maps each 802.1p priority to its default internal traffic class value.
Format
no classofservice dot1p-mapping
Modes
• Global Config
• Interface Config

classofservice ip-dscp-mapping

This command maps an IP DSCP value to an internal traffic class. The <ipdscp> value is
specified as either an integer from 0 to 63, or symbolically through one of the following
keywords: af11, af12, af13, af21, af22, af23, af31, af32, af33, af41, af42, af43, be, cs0, cs1,
cs2, cs3, cs4, cs5, cs6, cs7, ef.
The <trafficclass> values can range from 0-6, although the actual number of available
traffic classes depends on the platform.
Format
classofservice ip-dscp-mapping <ipdscp> <trafficclass>
Modes
Global Config
no classofservice ip-dscp-mapping
This command maps each IP DSCP value to its default internal traffic class value.
Format
no classofservice ip-dscp-mapping
Modes
Global Config
ProSafe Managed Switch
Voice VLAN Commands
Quality of Service (QoS) Commands
440
.
on page 62