Ip Ospf Mtu-Ignore; Router-Id (Ospf); Redistribute (Ospf) - NETGEAR ProSafe M7100-24X User Manual

ip ospf mtu-ignore

This command disables OSPF maximum transmission unit (MTU) mismatch detection. OSPF
Database Description packets specify the size of the largest IP packet that can be sent
without fragmentation on the interface. When a router receives a Database Description
packet, it examines the MTU advertised by the neighbor. By default, if the MTU is larger than
the router can accept, the Database Description packet is rejected and the OSPF adjacency
is not established.
Default
enabled
Format
ip ospf mtu-ignore
Mode
Interface Config
no ip ospf mtu-ignore
This command enables the OSPF MTU mismatch detection.
Format
no ip ospf mtu-ignore
Mode
Interface Config

router-id (OSPF)

This command sets a 4-digit dotted-decimal number uniquely identifying the router ospf id.
The <ipaddress> is a configured value.
Format
router-id <ipaddress>
Mode
Router OSPF Config

redistribute (OSPF)

This command configures OSPF protocol to allow redistribution of routes from the specified
source protocol/routers.
Default
• metric—unspecified
• type—2
• tag—0
Format
redistribute {rip | static | connected} [metric <0-16777214>]
[metric-type {1 | 2}] [tag <0-4294967295>] [subnets]
Mode
Router OSPF Config
ProSafe Managed Switch
Routing Commands
278