Steering Angle Sensor - Honda Acura NSX 1991 Service Manual

Electronic Compornents
Steering Angle Sensor Replacement
Removal:
Remove the steering column covers.
Disconnect the 5-P connector from the steering an-
2 .
gle sensor.
Remove the steering angle sensor mounting bolts,
3 .
then remove the steering angle sensor.
NOTE: Take care not to drop the adjusting shim
used between the steering angle sensor and sensor
mounting bracket.
CAUTION: Handle with care not to damage or drop
the steering angle sensor as it is sensitive.
SENSOR
19-l 38
Installation:
1 . Install the steering angle sensor by tightening 2 bolts
and make sure the adjusting shim is installed
properly.
CAUTION: Do not apply any grease or oil to the ad-
justing shim.
Detect
part.
BOLTS'.
10 N-m (1.0 kg-m,, 7.2 lb-ft)
2. Connect the 5-P connector to the steering angle
sensor.
3. Install the steering column covers.
4. Perform the steering angle sensor system check (See
page 19-96).
If there is an abnormalty, check the troubleshoot-
ing flowchart (see page 19-96).
NOTE:
the steering angle sensor is replaced.
Use the original shim.
adjusting the air gap) is required only when the
steering column assembly (without the sensor) is
replaced.
STEERING
' A N G L E
SENSOR