Rear Hatch Glass Molding
5.
Scrape all traces of old molding from the chamfered
edges of the glass.
NOTE: Be sure to scrape all traces of old molding
thoroughly.
Clean the glass surface with alcohol where new
6.
molding is to be installed.
NOTE: Make sure the surface is kept free of water,
oil and grease.
With a brush, apply a light coat of glass primer
7.
around the edge of the glass.
.
.
NOTE: Scrape off excess glass primer with a putty
knife after installing the new molding.
Degrease the inner surfaces of the new molding
8.
thoroughly, then apply a light coat of glass primer
to the surfaces.
NOTE:
the new molding.
l
Do not apply glass primer to the outer surface.
9. Run a bead of adhesive in the groove of the
molding.
20-36
10. Press the molding into position around the entire
EXCESS
PRIMER
11. Scrape or wipe the excess adhesive off with a put-
(Glass Surface)
edge of the glass.
NOTE: Check that the molding is not wrinkled or
lifted away at the corners.
ty knife or gauge.
NOTE: Use a soft shop towel dampened with
alcohol to remove adhesive from a painted surface,
upper seal, lower fastener or glass.
Outside:
t Z-T
Surface to be
wiped clean.