Honda Acura NSX 1991 Service Manual page 535

Shift Cable
1 . Start the engine. Shift to reverse to see if the reverse
gear engages. If not, refer to Troubleshooting on
pages 14-84 thru 14-87.
2. Stop the engine.
3 . Raise the car. (See page I-6.)
4. Shift the selector lever to 1 position.
5 . Remove the shift cable cover.
6 . Remove the control lever pin and lock pin from the
control lever.
CONTROL LEVER PIN
LOCK PIN
Install in this
direction.
7 . Shift the control lever to 1 position.
NOTE: 1 position moves the control lever toward to
the front of the car.
SHIFT CABLE COVER
B N-m (0.8 kg-m, 6 lb-W
8. Check that the hole in the control lever is perfectly
aligned with the hole in the shift cable.
CONTROL LEVER
, SHIFT CABLE END
\
Cable
Cable
Too Short
Too Long
9 . If not perfectly aligned, loosen the locknut on the shift
cable and adjust as required.
LOCKN
NOTE: Left-hand
threads
10. Tighten the locknut.
11. Install the control lever pin and lock pin.
NOTE:
stall it, the cable is still out of adjustment and must
be readjusted.
Install the lock pin as shown in step 6.
l
12. lntall the shift cable cover.
13. Start the engine and check the shift lever in all gears.
If any gear does not work properly, refer to
Troubleshooting on pages 14-84 thru 14-87.
Exact
Alignment
ADJUST NUT
LOCKNUT
14-I 53