Honda Acura NSX 1991 Service Manual page 785

Troublshooting
(Form palge 19-96)
Connect the voltmeter between
the No. 2 (+I and No. 5 (-1 ter-
minals of the steering angle
sensor.
Does the needle pulse
repeatedly?
Turn the steering wheel slowly
Check for open or short in the LT
and LT GRNlWHT wire
between the steering angle sen-
sor and TCS control unit. (Refer
to 5 and 6.)
If there is no open or short-circuit,
check for poor connections or
loose wires. If the connections
substitute a known-good TCS
control unit and recheck.
19-98
WIRE
N O
Turn the ignition switch OFF.
I
I
Disconnect the
from the steering angle sensor.
Check for resistance between the
is there co or 0 C?
N O
(To page IQ-991
Turn the ignition switch OFF.
Disconnect the 5-P connector
from the steering angle sensor.
Check for resistance between the
1
Is there 00 or 0 O?
, I
5-P connector
NOTE:
Resistance is approximately 50 kD.
1
NOTE:
Resistance is approximately 50 kD.
NO
tween the No. 3 terminal and TCS
control/unit.
R E
Use the digital multimeter.
Use the digital multimeter.
I
wire be-