Honda Acura NSX 1991 Service Manual page 837

NOTE: Lower the window fully.
1 . Remove: (See pages 20-6, 7)
2 . Pry the clips out using a flat tip screwdriver, then
pull up the moldings.
3. Set the clips on to the molding, 'then install the
molding in the reverse order removal.
inner molding:
INNER MOLDING
INNER MOLDING
Outer molding:
NOTE:
molding mounting screw.
forward.
STABILIZER
Lower the window fully.
1 .
2.
Remove the seat (page 20-38).
3.
Disconnect the door harness
4. Remove the door assembly by removing the hinge
bolts, detent rod pin and pulling out the wire
harness.
CAUTION: Place a shop towel and rubber pad on
the jack to prevent damage to the door.
5. Install the door assembly in the reverse order of
removal.
NOTE: Adjust the door position (page 20-I 8).
connectors.
30 N-m (3.0 kg-m
20-I 1