Honda Acura NSX 1991 Service Manual page 578

-Removal (cont'd)
7. Disconnect the connectors from the horn and cruise
control set/resume switches remove the airbag con-
nector from its dips.
CRUISE CONTROL
SET/RESUME
CONNECTOR
-Disassembly/Reassembly
Store a removed airbag assembly with the
pad surface up. If the airbag is improperly stored face
down, accidental deployment could propel the unit with
enough force to cause serious injury.
NOTE: If an intact airbag assembly has been re-
moved from a scrapped car or has been found defec-
tive or damaged during transit, storage or service,
it should be deployed (See section 23).
ST
L O
MAINTENANCE
LID
SWITCHES
STEERING WHEEL
CRUISE CON+ROL SET/
RESUME SWITCH
8. Remove the steering wheel nut.
9. Remove the steering wheel by rocking it slightly from
side-to-side as you pull steadily with both hands.
CAUTION:
l Carefully inspect the airbag
ing. Do not install an airbag assembly that shows signs
of being dropped or improperly handled, such as dents,
cracks or deformation.
Always keep the short connector on the airbag con-
l
nector when the harness is disconnected.
l Do not disassemble or tamper with the airbag as-
sembly.
(1.0 kg-m, 7 lb-ft)
Replace.
STEERING WHEEL
NUT
Replace. \
assembly before install-
17-Q