Transmission Assembly; Installation - Honda Acura NSX 1991 Service Manual

Transmission Assembly

NOTE: Check that the two dowel pins are installed in the clutch housing.
1. Place the transmission on the transmission jack, and raise it to the engine level.
2. Set the release fork to the clutch housing. (See page, 13-9)
3. Install the 2 transmission housing mounting bolts and engine stiffener.
4. Install the 3 rear transmission mounting bolts.
5. Loosen the front engine mounting bolt, then install the 2 front engine
mounting <bolts to the transmission side.
6. Remove the transmission jack.
7. Install the clutch housing cover.
MOUNTING BOLTS
12 x 1.25 mm
(10.5 kg-m, 76 lb-ftj
8. Install the slave cylinder.
9. Install the shift cable and select cable.
CAUTION: Take care not to bend the cables.
10. Install the upper cover, change wire bracket and lower cover.,
1 1. Install the upper control arm mounting bolt.
22 N-m (2.2 kg-m,
16 lb-ft)
COTTER PIN
Replace.
6 x l.Omm
12 Nom II .2 ko-m.*
9
26 N*m (2.6 kg-m, 19 lb-ft) 12 N-m (1.2 kg-m, 9 lb-ft)
13-48
TRANSMISSION'
JACK
6 x 1:Omm
45 N*m (4.5 kg-m, 33 lb-ft)
TRANSMISSION HOUSING MOUNTING BOLT
12x 1.25 mm
65 N-m (6.5 kg-m, 47 lb-ft)
60 N-m (6.0 kg-m, 43 lb-ft)
16.5 kg-m, 47 lb-ft)
E N G I N E
MOUNTING BOLT
60 N*m (6.5 kg-m, 43 lb-ft)
8 x I.25 m m
6 x l . O m m