Honda Acura NSX 1991 Service Manual page 662

7. Remove the 6 mm brake disc retaining screws.
Screw two 8 x 12 mm bolts into the disc to push it
away from the hub.
NOTE: Turn each bolt two turns at a time to pre-
vent cocking the disc excessively.
8. Remove the hub unit from the knuckle.
*SELF-LOCKING
1 0 x 1.25mm
Replace.
65
*Corrosion resistant bolt/nut
8 x 12'mm
DISC
b o l t s
NUT
FRONT fiU8 UNIT
Front Wheel Bearing Replacement:
Attach the special tool to the hub and tighten the
1 .
nuts, then set the special tool in a vise and secure
it.
2. Pry the spindle nut stake away from the spindle,
then remove the spindle nut.
SPINDLE NUT
26 x 1.5
mm
3. Remove the special tool.
Remove the pulser using a commercially available
4.
bearing puller.
FRONT HUB HOLDER
ER
18-17