Honda Acura NSX 1991 Service Manual page 835

14. Remove the 2 locknuts, then remove the rear glass
guide.
NOTE:
removing the locknuts.
original adjustment.
15. Before removing the latch assembly and lock
cylinder, raise the window fully by connecting a 12
. . V battery to the regulator motor (See Section 23).
16. Remove the retainer by sliding it forward. Pry the
lock rod out its joint using a flat tip screwdriver,
then carefully remove the lock cylinder.
17. Disconnect the rod and remove the inside crank.
ADJUSTING BOLT
22 kg-m,
- - - -
18. Lower the window and remove the mounting nuts,
STOPPER
22 Nom (2.2 kg-m,
18 lb-f%)
Remove the cable and harness clips.
Remove the mounting screws, then remove the
latch assembly through the hole in the door.
NOTE: Take care not to bend the lock rod.
LATCH ASSEMBLY ,
then remove the stopper plates.
NOTE:
to the regulator motor (See Section 23).
the original adjustment.
PLATES
INSIDE CRANK