Honda Acura NSX 1991 Service Manual page 531

Transmission
1.
Place the transmission on the transmission jack, and raise to the engine level.
2.
3. Install the 3 transmission housing mounting bolts.
4. Install the 3 rear transmission mounting bolts.
6. Remove the transmission jack.
7 . Attach the torque converter to the drive plate with 8 bolts to 12 N-m (1.2 kg-m, 9 lb-ft). Rotate the crankshaft as necessary
to tighten bolts to l/2 of specified torque, then final torque, in a crisscross pattern. Check for free rotation after tightening
the last bolt.
8. Install the torque converter cover.
9. Install the shift cable, shift cable holder and shift cable cover.
10. Install the upper control arm mounting bolt.
6x l.Omm
12
kg-m, 9 lb-ft)
CONTROL LEVER
CONTROL LEVER
PIN
LOCK PIN
Install in this
direction.
MOUNTING BOLT
10x 1.25mm
60
(6.0
kg-m, 43 lb-ft)
TRANSMISSION JACK
6 x l.Omm
1 2 N.m
(1.2 kg-m, 9 lb-ftl
1 0 x 1.25mm
60
TRANSMISSION HOUSING
MOUNTING BOLT
MOUNTING BOLT
10x 1.25mm
65