Honda Acura NSX 1991 Service Manual page 654

Caster
Loosen the pivot adjuster mounting nuts under
l
the compliance pivot and adjust the cam posi-
tion so that the right and left gaduations on the
adjusting cam are in contact with the groove
walls.
Graduation in contact
with groove wall
4. Measure and record the readings for the camber
and toe according 'to the alignment equipment
manufacture's instructions.
5 .
Graduation in
contact with
6. Measure the caster according to the alignment
7. Adjust the caster.
8.
9.
Front
T o e
Camber -0 dagrees 20' -I 30'
Caster +8,degrees
Adjust the camber and toe at the same time on one
side of the car. Repeat for the other side of the car.
NOTE:
equals approximately 10 minutes of camber
change.
8 mm.
equipment manufacture's instructions.
NOTE: One graduation on the caster adjusting
cam equals approximately 10 minutes of caster
change.
Measure the readings for camber and toe.
Readjust the camber and toe to the specifications
shown.
Specifications
-3.5 mm -+ 1.0 mm
00' -t 45'
18-9