Honda Acura NSX 1991 Service Manual page 524

Manual Valve Detent Spring
NOTE: Select the appropriate manual valve detent
spring when below parts are replaced.
Manual Valve
l
1 . Install the main valve body, including the oil pump
gears, onto the torque converter housing and tight-
en to 12 N-m (1.2 kg-m, 9 lb-ft).
See page 14-143.
2. Install the control shaft.
3. Install the manual valve detent spring on the main
valve body and tighten to 14 N-m (1.4 kg-m, 10
lb-ft).
4. Set the manual valve to N position.
5 . Measure the distance between the main valve body
and manual valve as shown.
DISTANCE: 28.0-29.0 mm (1.102-1.142 in)
BODY
MAIN
M A N U A L VAlcE
LEVER
6. If the measurement is out of tolerance, select the
appropriate manual valve detent spring using table
below, then install it and recheck.
MANUAL VALVE DETENT SPRING
No. Part Number
1
3
r
LENGTH
MANUAL VALVE
DISTANCE
MANUAL
VALVE
DETENT SPRING
N positicn
Length
mm (4.07 in)
103.5
mm (4.09 in)
104.0
I
104.5 mm (4.11 in)
Parking Brake Stopper
1 . Set the parking shift arm in the PARK position.
2. Measure the distance between the face of the park-
ing pawl shaft and face of the parking shift arm roller
pin as shown.
DISTANCE: 52.1-53.1
DISTANCE
P A R K I N G
SHIFT ARM,
3. If the measurement is out of tolerance, select the
appropriate parking brake stopper using the table be-
low, and install it on the parking shift arm.
PARKING BRAKE STOPPER
mm (2.051-2.091
PARKING PAWL
BRAKE STOPPER