Honda Acura NSX 1991 Service Manual page 641

en the locknut while holding the rack guide screw with
a wrench.
NOTE: The above specification is the torque wrench
reading (indicated) when the locknut is tightened us-
ing a torque wrench 50 cm (20 inches) long. If you
tighten the locknut using a torque wrench of a differ-
ent length, obtain the indicated torque
wrench reading) using the following formulas.
Y x Actual torque =X
X = Torque wrench reading.
Actual: 25N.m (2.5 kg-m, 18 lb-ft)
Indicated: 19N.m (1.9 kg-m, 14 lb-ft)
Tool length (8): 15 cm (6 in)
17-70
value (torque
40 mm, LOCKNUT WRENCH
40 mm, LOCKNUT
WRENCH
1 OA
Tie-rod installation:
5 . Screw each rack end into the rack while holding the
lock washer so its tabs are in the slots in the rack
end.
NOTE: Install the stopper washer with the cham-
fered side facing out.
6. Tighten the rack end securely, then band the lock
washer back against the flat on the flange as shown.
NOTE: Coat the stopper washer with grease suffi-
ciently.
55N.m
(5.5 kg-m, 40 lb-ft)
\