Honda Acura NSX 1991 Service Manual page 1252

Power Windows
Motor Test:
Remove the door trim panel (see section 20).
1 .
2. Disconnect the 4-P connector from the driver's
motor.
3. Test motor operation by connecting battery voltage
to the No. 1 and No. 2 terminals.
Test the motor in each direction, by switching the
leads from the battery.
CAUTION: When a motor stops running, disconnect-
ed battery terminal
4. If the motor does not run, replace it.
Using an analog ohmmeter, running the motor by con-
necting battery voltage to the No. 1 and No. 2 terminals,
check for needle movement when connecting the test
leads to the No. 3 and No. 4 terminals.
The analog ohmmeter needle should move back and forth
alternately.
23-268
immediately.
Remove the door trim panel (see section 20).
1 .
2. Disconnect the 2-P connector from the motor.
Test motor operation by connecting battery voltalge
3.
to the No. 1 and No. 2 terminals.
Test the motor in each direction, by switching the
leads from the battery.
CAUTION: When a motor stops running, disconnect-
ed battery terminal immediately.
4. If the motor does not run, replace it.
View
from wire side