Honda Acura NSX 1991 Service Manual page 577

Steering Wheel
-Removal
Store a removed airbag assembly with the
pad surfce up, if the airbag is improperly stored face
down, accidental deployment could propel the unit with
enough force to cause serious injury.
CAUTION:
Before removing the steering wheel, aline the front
l
wheels straight ahead.
Do not install used SRS parts from another car.
l
When repairing, use only new SRS parts.
Carefully inspect the airbag
l
ing. Do not install an airbag assembly that shows signs
of being dropped or improperly handled, such as dents,
cracks or deformation.
l Always keep the short connector on the airbag con-
nector when the harness is disconnected.
Do not disassemble or tamper with the airbag as-
l
sembly.
1 . Disconnect both the negative cable and positive ca-
ble from the battery.
2 . Remove the maintenance lid form the steering wheel
lower cover, then remove the short connector.
Disconnect the connector between the airbag and
3.
cable reel.
4. Connect the short connector to the airbag side of
the connector.
MAINTENANCE
CABLE REEL 3-P\ SAORT CONNECTO;
CONNECTOR
assembly before install-
'CONNECTOR
5 . Remove the two TORX@ bolts using a TORX@ T30
bit, then remove the airbag assembly.
CRUISE CONTROL SET/RESUME
SWITCH
BOLTS
BOLT
ASS
EMBLY