Honda Acura NSX 1991 Service Manual page 642

7. install the boots on the rack end with the tube
clamps.
NOTE:
Coat the rack end and inside of the boot with the
l
grease.
sure inside of the boot is the atmospheric
pressure.
ahead condition (i.e. right and left tie-rods are
equal in length).
8. Install the new boot bands on the boot and bend both
sets of locking tabs.
Lightly tap on the doubled portions to reduce their
height.
NOTE: After assembling, slide the rack right and left
to be certain that the boots are not deformed or
twisted.
LOCKING TABS
(Honda P/N 08733-B070E)
Coat inside of the boot.
the
SILICONE GREASE
Coat the sliding surface
,of the rack end.
BOOT BAND
9. If the tie-rod ends were removed, install the tie-rods
on the right and left rack ends and screw them in
until the threaded section is 11 mm (0.43 in.) in
length.
Hand tighten.
10. Install the gearbox and the cross-beam (17-66).
Check the wheel alignment and adjust if necessary
(Section 18).
11 mm (0.43 in.)
TIE-ROD END
J
17-71