Honda Acura NSX 1991 Service Manual page 1142

Shift Lever Position Indicator
-Shift Position Console Switch Test
CAUTION:
All SRS electrical wiring harness& are covered
l
with yellow outer insulation.
l Replace the entire affected SRS harness assem-
bly if there is an open circuit or damage to the
wiring.
1 . Remove the console, then disconnect the 12-P and
2-P connectors from the console switch.
Check for continuity between the terminals in each
2.
switch position according to the table.
NOTE:
the push button at each switch position, and
check for continuity within a range of free play
of the shift lever.
If there's no continuity within the range of free
l
play, adjust the installation position of the con-
sole switch.
Shift Position Console Switch
R 0
P
Adjustment:
1.
Shift to the "P" position, then loosen the bolts.
2. Slide the switch in the direction of D position [wi-
thin 2.0 mm (0.079 in)1 so that there is continuity
between No. 8 and No. 11 terminals (within the
range of free play of the shift lever).
3. Recheck for continuity between each of the ter-
minals.
NOTE:
l If adjustment is not possible, check for damage
to the shift lever detent and/or bracket.
If there is no damage, replace the console switch.
The engine should start when the shift lever is in
l
N position (within the range of free play).
23-l 56
View from wire side.
Back-up
Light Switch
0 0
0
Neutral
Safety Switch
3
0 0