Honda Acura NSX 1991 Service Manual page 840

Doors
NOTE: Make sure the door position is adjusted properly
before adjusting the glass (page 20-I 8).
1. Remove the door trim (page 20-37).
2. Remove the weatherstrip (page 20-20).
NOTE: Check the weatherstrip for damage or
deterioration and replace if necessary.
3. Remove all retainers by removing the attaching
screws (page 20-20).
4. Remove the door panel and peel off the plastic
cover (pages 20-6, 7).
5. Remove the control switch panel from the door
panel (page 20-7).
6. Connect the connector of the control switch panel
to the door harness.
NOTE: Take care not to scratch or score the con-
trol switch panel.
7. Carefully close the door while holding the window
glass to prevent it from contacting the body panel.
8. Close the door glass fully.
NOTE: Check the door fit to the body opening.
9. Measure and record the clearance "H" and "B"
between the glass and body at the locations
shown.
10. Adjust the clearance as described in the following
Section: @I - @
WINDSHIELD
G L A S S
Section: @ - @
Section: @
"H" Clearance
(Standard Clearance)
Measuring
Point
L
Clear-
ance
H" Clearance
"B" Clearance
Unit: mm (in.)