Honda Acura NSX 1991 Service Manual page 1322

Supplemental Restraint System (SRS)
Store a removed airbag assembly
with the pad surface up, if the airbag is improperly
stored face down, accidental deployment could
propel the unit with enough force to cause serious
injury.
CAUTION:
When repairing, use only new SRS parts.
l Carefully inspect the airbag
stalling. Do not install an airbag assembly that
shows signs of being dropped or improperly han-
died, such as dents, cracks or deformation.
Always keep the short connector on the airbag
l
connector when the harness is disconnected.
Do not disassemble or tamper with the airbag as-
l
sembly.
1 . Disconnect the battery negative terminal, then dis-
connect the positive
2.
Remove the maintenance lid A below the airbag,
then remove the short connector.
"MAINTENANCE
LID-A
23-338
assembly before in-
terminal.
3. Disconnect the connector between the airbag
cable reel.
4. Connect the short connector to the airbag side of
the connector.
CONNECTOR
5. Remove the 3 TORX@ bolts using TORX@ T30 bit,
then remove the airbag assembly.
CRUISE CONTROL
SWITCH
and
CABLE REEL
SHORT CONNECTOR (RED)
SET/RESUME