Honda Acura NSX 1991 Service Manual page 865

Seat Belts
CAUTION: Check the seat belts for damage and replace them if necessary. Be careful not to damage them during
removal and installation.
NOTE: Remove the anchor bolts with a 17 mm socket or box-end wrench.
1 . To remove the seat belts, first remove the seats (page 20-38).
NOTE: Take care not to scratch the interior trim, dashboard and center armrest.
2. Remove the cap and remove the lower anchor bolt.
3. Remove the center anchor bolt, and disconnect the connector.
4. Remove the rear pillar trim panel and side panel (page 20-37).
5. Remove the upper anchor bolt and retractor bolts.
RETRACTOR BOLT
32 N-m (3.2 kg-m, 23 lb-ft)
6. Check that the retractor locking mechanism func-
tions as described on page 20-40.
7. Install the front seat belts in the reverse order of
removal.
NOTE:
lars on the upper and lower anchor bolts as
shown.
sure there are no twists or kinks in the belts.
use liquid thread lock.
TOOTHED
LOCK WASHER
TOOTHED
LOCK WASHER
\
REAR PILLAR TRIM
(Replacement, page
32 Nom (3.2 kg-m, 23 lb-ft)
2 0 - 3 9